Spectra T950 - Connecting a USB Device to the Library

Chapter 5 — Operating the Library Using a USB Device
November 2016 User Guide—Spectra T950 Library
179
Connect a USB Device to the Library
Notes:  WhenconnectingtheUSBdevicetotheLCM,makesurethat
youdonotinadvertentlyconnectittotheRCM.SeeFigure17
onpage45toidentifytheLCM.
 ThelibraryonlyrecognizesFAT‐formatted,notNTFS‐
formatted,USBdevices.
 NotallUSBdevicesarecompatiblewiththelibrary.Ifyou
areunabletoaccessaUSBdevicefromthelibrary,removeit
anduseadifferentone.IftheLCMstopsrespondingafter
youinsertanincompatibleUSBdevice,reboottheLCMas
describedinResettheLCMorRCMonpage369.
 PlugtheUSBdeviceintotheLCMbeforebeginninga
procedurethatreadsorwritesdatatoallowtimefordevice
recognition.Formanyutilities,theoptiontoreadfromor
writedatatoaUSBdeviceisnotavailableifaUSBdevice
wasnotpluggedintotheLCMandallowedenoughtimeto
mountbeforeyouselecttheutility.
UsethefollowingstepstoconnectaUSBdevicetothelibrary.
1. LocatetheUSBportyouwanttouseontheT950BoperatorpanelorLCM.
2. PlugtheUSBdeviceintotheUSBportandallowtimeforthedeviceto
mount.
Important
Unless specifically instructed to do so, do not connect a USB device to the USB port
on the RCM.
Figure 111 Location of the USB port on the Spectra PC.
Figure 112 Location of the USB ports on the Spectra LS.
USB port
USB ports