Spectra T950 - SETTING THE CAMERA IP ADDRESS

Chapter 4 — Configuring the Library Setting the Camera IP Address
November 2016 User Guide—Spectra T950 Library
150
SETTING THE CAMERA IP ADDRESS
EachBlueScaleVisioncamerarequiresauniqueIPaddress.ThecameraIP
addressesareseparatefromtheIPaddressusedforcommunicationswith
thelibrary.
1. ConnectanEthernetcablefromtheBlueScaleVisioncameraconnector
onthebackoftheframecontainingthecameradirectlytoacomputer
ortoanetworkthatisaccessibletothecomputerthatwillbeusedto
configurethecamera.TheBlueScaleVisioncameraconnectorislocated
atthetopleftofeachframethatcontainsacamera.
Notes:  WhenyouperformtheinitialIPaddressconfigurationforthe
camera,itmaybehelpfultoconnectacomputerdirectlyto
theBlueScaleVisioncameraconnectorforonecameraata
timeinsteadofusingaconnectionoveranetwork.
 Dependingonhowthecomputeryouareusingis
configured,youmayneedtotemporarilychangethe
computer’snetworksettingssothatitcanaccessthecamera.
Thefactorydefaultsettingsforallcamerasare:
Note: InordertocomplywithEMCrequirements,useashielded
Ethernetcabletoconnectthecameratoyournetwork.
IP Address Subnet Mask Default Gateway
10.10.10.11 255.255.255.0 10.10.10.1
Figure 82 Location of the camera Ethernet port.
BlueScale Vision
camera connector
Media Expansion Frame
BlueScale Vision
camera connector
Main or Drive Expansion Frame