Spectra T950 - Page 130

Chapter 4 — Configuring the Library Configuring Optional Library Settings
November 2016 User Guide—Spectra T950 Library
130
2. Fromthetoolbarmenu,selectConfiguration > Controllerstodisplay
theControllersscreen.
3. Identifythecontrollerthatyouconfiguredtoprovidetherobotic
controlpathinapartition(seeSelecttheRoboticControlPathon
page194).Thiscontrolleristheprimarycontrollerinthefailoverpair.
Note: Ifyouhavenotyetconfiguredpartitions,identifytwo
controllers(RIMsorF‐QIPs).Bothcontrollersmustbeatthe
samefirmwareversion.IfoneisaRIM2,bothmustbeRIM2s.
4. ClickFailovernexttothecontrolleryouwanttobetheprimary
controllerinthefailoverpair.TheControllerFailoverscreendisplays
withalistoftheotherRIMsorF‐QIPsinthelibrarythatcanbeusedas
thefailoverpartner.
Notes:  ThecomponentidentifiersfortheRIMsshowthemasF‐QIPs. 
SeeRIMandF‐QIPIdentifiersonpage65formore
information.
 IfyouareconfiguringFailoverforaRIM2,onlyotherRIM2
controllersarelistedaspossiblefailoverpartners.
Figure 69 The Controllers screen before the failover
controller is selected.
Figure 70 The Controller Failover screen.