Spectra T950 - Page 148

Chapter 4 — Configuring the Library Backing Up the Library Configuration
November 2016 User Guide—Spectra T950 Library
148
4. SelecttheSave Library Configurationutility.Thescreenrefreshesto
showthedetailsfortheutility.
5. UsetheSelect the destinationdrop‐downlisttoselectwhereyouwant
tosavethefile.
Note: Donotusethecheckboxesatthetopofthescreen.Theyacton
theUtilityResultsmessage,nottheconfigurationfile.
6. ClickRun Utility.
Afterabriefdelay,theUtilityResultsscreendisplays,showingthatthe
configurationfilewaseithersavedorsent.
7. Confirmthatthebackupwassuccessful,asdescribedinVerifythe
ConfigurationBackup.
Figure 81 The Save Library Configuration utility.
Select... To. ..
save library
configuration to
USB
SavethelibraryconfigurationfiletotheUSBdeviceconnectedtoaUSBporton
theLCMorfrontpanel(T950Bonly).Thebackupfileisstoredinafoldercalled
SavedConfigs\<date-time>, where <date-time>isthetimestampfor
whenthebackupwascreated.Thefoldercontainsmultipleconfigurationfiles

withtheformatcnnnnnn.cfg,wherenisanumberbetween0and9.
mail library
configuration to
[mail recipient]
Sendthelibraryconfigurationfileasazipfileattachedtoanemailaddressedto
apreviouslyconfiguredmailrecipient(seeConfigureMailUsersonpage118).
Note: Donotmailthefiletoautosupport@spectralogic.comunlessSpectraLogic
TechnicalSupportspecificallyrequestedthefilefortroubleshooting.