Spectra T950 - Page 210

Chapter 6 — Configuring and Managing Partitions Creating a Storage Partition
November 2016 User Guide—Spectra T950 Library
210
3. Ifnecessary,configureanyadditionalports.
If the exporting
controller is a...
And... Then...
RIM  YouonlyselectedoneportontheRobotic
PathVisibilityscreen,
—OR—
 YoualreadyconfiguredbothFibre
Channelports,
ProceedtoConfirmingandSaving
thePartitionSettingsonpage211.
RIM YouselectedbothportsontheRobotics
Visibilityscreen,
1. Repeattheconfigurationstepsin
thissectiontoconfiguretheother
FibreChannelport.
2. Afteryoufinishconfiguringthe
secondport,proceedto
ConfirmingandSavingthe
PartitionSettingsonpage211.
F‐QIP  Allofthedrivesinthepartitionare
connectedtotheexportingF‐QIP,
—AND—
YouonlyselectedoneportontheRobotic
PathVisibilityscreen,
—AND—
YouselectedthesameportontheDrive
Visibilityscreen,
—OR—
 YoualreadyconfiguredallFibreChannel
ports,
ProceedtoConfirmingandSaving
thePartitionSettingsonpage211.
F‐QIP
 Allofthedrivesinthepartitionare
connectedtotheexportingF‐QIP,
—AND—
YouselectedbothportsontheRobotic
PathVisibilityscreenandtheDrive
Visibilityscreen,
—OR—
 Youselecteddifferentportsonthe
RoboticsVisibilityandDriveVisibility
screens,
1. Repeattheconfigurationstepsin
thissectiontoconfiguretheother
FibreChannelportonthe
exportingcontroller.
2. Afteryoufinishconfiguringthe
secondport,proceedto
ConfirmingandSavingthe
PartitionSettingsonpage211.
F‐QIP Someorallofthedrivesinthepartitionare
notconnectedtotheexportingF‐QIP,
1. Repeattheconfigurationstepsin
thissectiontoconfiguretheports
ontheF‐QIP(s)usedtoprovide
connectivityforthedrives.
2. Afteryoufinishconfiguringthe
remainingports,proceedto
ConfirmingandSavingthe
PartitionSettingsonpage211.