Spectra T950 - Page 482

Chapter 15 — Maintaining the Drives Updating Drive Firmware
November 2016 User Guide—Spectra T950 Library
482
2. TheStagedDriveFirmwareUpdatescreendisplays.
Selectorcleareachdrive’scheckboxtoindicatewhetherornotto
updatethedrive.
Note: Ifadriveisnotempty,itisstillincludedinthislist;however,its
checkboxisdisabled,withanoteindicatingthatatapeisloaded
inthedrive.
3. ClickNext.Thedrivefirmwareupdateprocessbeginsupdatingthe
selecteddrivesinparallel.Aprogressscreendisplaysuntiltheprocess
completes,inapproximately15to30minutes.
4. Afterthedrivefirmwareupdatecompletes,theStagedFirmware
UpdateResultscreendisplaystheresultsoftheupdateprocess.Click
OKtoreturntotheDrivesscreen.
5. Aftertheupdateiscomplete,useyourstoragemanagementsoftwareto
restartanybackupprocesses.
Figure 309 Select the drives to update.
The Drives screen displays... when...
Thelibrarystartsthefirmwareupdateprocess.
Thestagingstatuslinechangesto“Committing”.
Thedrivefirmwareupdateprocessiscomplete.
Thestagingdriveiconchangesbacktothedriveicon,
andthestagingstatuslinedisappears.
Figure 310 Click OK to return to the Drives screen.