Spectra T950 - Page 484

Chapter 15 — Maintaining the Drives Updating Drive Firmware
November 2016 User Guide—Spectra T950 Library
484
Perform the Update
1. Logintothelibraryasauserwithsuperuseroradministrator
privileges.
2. InsertoneormorefirmwareupdatetapesintoaTeraPackmagazine
(seeFigure144onpage224).Makeanoteofthebarcodelabelonthe
cartridgesothatyoucanidentifyitafteritisimported.
3. Importthemagazinecontainingthefirmwareupdatetape(s)intothe
entry/exitpoolforthestoragepartitionwherethedrivesarelocated.
4. SelectConfiguration > DLM(orDrives)todisplaytheDrivesscreen.
5. ClickDrive Firmware Updatetolaunchtheupdatewizard.TheDrive
FirmwareUpdatescreendisplaysshowingtheinformationforthelast
partitionthatwasviewed.
6. Selectth epartitioncontainingthedriv esyouwanttoupdatefromthe
drop‐downlist,thenclickGo.TheDriveFirmware Updatescreen
refreshesto showthedriv esassignedtotheselectedpartition.
7. Selectthedrivesthatyouwanttoupdate.
Figure 311 Click Drive Firmware Update on the Drives screen.
Figure 312 Select the partition for the drives you want to
update.
Important
If you have multiple drive generations in the same partition, make sure that you
only select one generation at a time. Each drive generation uses different firmware.