LL_DAC_OUTPUT_BUFFER_ENABLE
The selected DAC channel output is buffered:
higher drive current capability, but also higher
current consumption
LL_DAC_OUTPUT_BUFFER_DISABLE
The selected DAC channel output is not
buffered: lower drive current capability, but also
lower current consumption
DAC registers compliant with specific purpose
LL_DAC_DMA_REG_DATA_12BITS_RIGHT_ALIGNED
DAC channel data holding
register 12 bits right aligned
LL_DAC_DMA_REG_DATA_12BITS_LEFT_ALIGNED
DAC channel data holding
register 12 bits left aligned
LL_DAC_DMA_REG_DATA_8BITS_RIGHT_ALIGNED
DAC channel data holding
register 8 bits right aligned
DAC channel output resolution
DAC channel resolution 12 bits
DAC channel resolution 8 bits
DAC trigger source
DAC channel conversion trigger internal (SW start)
LL_DAC_TRIG_EXT_TIM2_TRGO
DAC channel conversion trigger from external IP:
TIM2 TRGO.
LL_DAC_TRIG_EXT_TIM8_TRGO
DAC channel conversion trigger from external IP:
TIM8 TRGO.
LL_DAC_TRIG_EXT_TIM4_TRGO
DAC channel conversion trigger from external IP:
TIM4 TRGO.
LL_DAC_TRIG_EXT_TIM6_TRGO
DAC channel conversion trigger from external IP:
TIM6 TRGO.
LL_DAC_TRIG_EXT_TIM7_TRGO
DAC channel conversion trigger from external IP:
TIM7 TRGO.
LL_DAC_TRIG_EXT_TIM5_TRGO
DAC channel conversion trigger from external IP:
TIM5 TRGO.
LL_DAC_TRIG_EXT_EXTI_LINE9
DAC channel conversion trigger from external IP:
external interrupt line 9.
DAC waveform automatic generation mode
LL_DAC_WAVE_AUTO_GENERATION_NONE
DAC channel wave auto generation
mode disabled.
LL_DAC_WAVE_AUTO_GENERATION_NOISE
DAC channel wave auto generation
mode enabled, set generated noise
waveform.
LL_DAC_WAVE_AUTO_GENERATION_TRIANGLE
DAC channel wave auto generation
mode enabled, set generated
triangle waveform.
DAC wave generation - Noise LFSR unmask bits
LL_DAC_NOISE_LFSR_UNMASK_BIT0
Noise wave generation, unmask LFSR
To Next Page
Loading...
Need help?
General
