9
3. Type the default user name and password (both of them are admin), then press the Enter
button so as to enter User EXEC Mode.
Figure 1-6 Enter into the User EXEC Mode
4. Type enable command to enter Privileged EXEC Mode.
Figure 1-7 Enter into the Priviledged EXEC Mode
Now you can manage your switch with CLI commands through Telnet connection.
Login Mode
Firstly configure the Telnet login mode as “login” and the connection password as 456 in the
prompted DOS screen shown in Figure 1-8.
Figure 1-8 Configure login mode
To Next Page
Loading...
