WEILER E2850 REMIXING TRANSFER VEHICLE
3-53
Operating Instructions
3
Machine Cleanup
5. Use Manual Hopper Switch (4) to reverse augers. If
material is in hopper, alternate switch between
reverse and forward to rock augers to dislodge
material.
6. Turn engine off and remove ignition key. Remove
material off of cleanout doors and from inside the
hopper. Clean the sealing edges of the doors and
openings thoroughly to enable doors to fully close.
7. Close and latch doors.
NOTICE: To prevent cleanout doors from opening
during roading or operation, ensure latches (2) are
locked.
Entanglement in rotating augers can crush or cut off hands and feet.
Stay away from rotating augers. Keep auger guards in place during
operation. Turn engine off and remove ignition key when servicing or
cleaning augers.
To Next Page
Loading...
