WEILER E2850 REMIXING TRANSFER VEHICLE
3-23
Operating Instructions
3
Preparing Machine
Windrow To Dump Hopper Conversion
Windrow Components Removal
1. Remove front cross member (1), if equipped.
2. If equipped, remove optional windrow shaper (2) by
removing 8 bolts (3) from inside elevator side panels.
3. Fully raise elevator.
WARNING
Falling load can crush.
Never work under lifted load unless load is securely supported to prevent
falling.
WARNING
Pressurized fluid can penetrate body tissue and result in death or serious
injury. Leaks can be invisible. Keep away from any suspected leak. Relieve
pressure in the hydraulic system before searching for leaks, disconnecting
hoses, or performing any other work on the system. When searching for a
pressurized leak, use an object such as a piece of wood or cardboard. Keep
hands away. When loosening a fitting where residual pressure may exist,
slowly loosen fitting until fluid begins to leak. Wait for leaking to stop before
disconnecting fitting. Tighten all connections before repressurizing system.
Seek immediate surgical treatment if fluid is injected under the skin.
To Next Page
Loading...