WEILER E2850 REMIXING TRANSFER VEHICLE
5-35
Maintenance
5
Maintenance Procedures
Hydrostatic Creep - Check
1. With machine on a level surface, place Propel Lever in neutral and turn elevator and conveyor
drive switches off.
2. Start engine and increase engine speed to full rpm.
3. Release park brake.
4. Ground drive, elevator, and conveyors must not move.
5. Contact a Weiler dealer if movement occurs.
Runover possible. Contact with moving parts can cut or crush.
Make sure no one is working on, underneath, or close to machine before
starting engine or moving machine. Ensure area is free of personnel. Keep
spectators away.
To Next Page
Loading...
