Weiler E2850 - Discharge Conveyor Cleanout

WEILER E2850 REMIXING TRANSFER VEHICLE
3-55
Operating Instructions
3
Machine Cleanup
Discharge Conveyor Cleanout
The discharge conveyor is equipped with access doors to the conveyor slats and chain for inspection,
cleaning and material removal. If a stalled discharge conveyor cannot be started by alternating
conveyor between reverse and forward, use the following steps to remove material to free the
conveyor.
1. Use Manual Conveyor Switch (1) to reverse
discharge conveyor if conveyor is empty.
If discharge conveyor is full, alternate switch (1)
between reverse and forward to jog conveyor chain
to attempt to free stalled conveyor.
To open discharge conveyor cleanout doors:
2. Release draw latches (2) on both sides of bottom door
(3).
1
2
3