1
WEILER E2850 REMIXING TRANSFER VEHICLE
3-56
Operating Instructions
3
Machine Cleanup
3. Open doors using Discharge Conveyor Cleanout
Doors Lever (4) on right side of machine.
4. Remove material by alternating forward and reverse motion of the conveyor.
5. Turn engine off and remove ignition key. Remove material from doors. Clean sealing edges of the
doors and opening thoroughly to enable doors to fully close.
6. Close and latch cleanout doors.
Falling door can crush. Door can open unexpectedly when stuck closed.
Pry door free before raising conveyor fully. Keep clear of raised door.
Moving conveyor slats can crush or cut off fingers and hands.
Never reach into conveyor chute or insert a cleanout tool into conveyor
chute when conveyor is moving. Turn engine off before cleaning or
working on conveyor.
To Next Page
Loading...
