13 Description of Units and Circuit Boards
DX100 13.9 Robot Specific Input Terminal Block (MXT)
13-25
3. Wire Connection
(1) Place the screwdriver on the lever upright as shown in the figure
below and push straight down.
(2) Insert the wire into the connection hole slowly until its leading end
touches the end of the hole.
For thin wires, never insert the wire with force, or the wire
jacket may get caught in.
(3) Pull out the screwdriver to clamp the conductor with a spring.
(4) Check if the wire is connected firmly by pulling the wire softly.
250
209-188
250
250
Terminal block: screwless clamp
terminal WAGO series 250
To Next Page
Loading...
