YOKOGAWA DL6000 Series

Triggering
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Index
App
6-11
IM DLM6054-01EN
Configuring the Level, Coupling, HF Rejection, Hysteresis, and
Window Comparator Settings (Level/Coupling)
You can set the level (the trigger level for the trigger source channel and the level used to determine
high/low states for channels with conditions applied to them), coupling, HF rejection, hysteresis, and
window comparator settings for each channel.
Press the Level/Coupling soft key to display the following menu.
Select a channel (CH1-CH4).
Set the HF rejection (OFF, 20 MHz, 15 kHz).
Set the coupling (AC, DC).
When Source Is Set to a Channel from CH1 to CH4
Turns the window comparator on and off
Set the hysteresis ( , ).
When Source Is Set to EXT
Select a channel
(CH1-CH4).
Set the trigger level.
Set the probe attenuation
(1:1, 10:1).
Set the values used to determine the
trigger level and the H, L, IN, and OUT
states.
ENHANCED Logic Edge Qualified Menu (DLM6000)
Set a trigger using a logic signal bit as the trigger source.
Press ENHANCED, the Type soft key, the Edge/State soft key, and then the Logic Edge (Qualified)
soft key to display the following menu.
Select the source bit (A0-A7, B0-B7, C0-C7, D0-D7).
Set the trigger slope ( , ).
Press to set a pattern to use as a qualification.
Set the logic (AND, OR).
6.4 Triggering on an Edge Condition