YOKOGAWA DL6000 Series User Manual

18-4
IM DLM6054-01EN
Item Specifications
Trigger type (A trigger) Edge:: Triggers on the edge of a single trigger source
The source can be set to a signal from CH1 to CH4, PodA(0 to 7) to PodD (0 to
7)
3
, EXT, or LINE
Edge OR:: Triggers when any of the edge trigger conditions of multiple trigger sources is
met
The source can be set to a signal from CH1 to CH4 (Max.50 MHz)
Edge Qualified:: Triggers on the edge of a single trigger source while qualifications are met
The source can be set to a signal from CH1 to CH4, or EXT. Qualifications can
be specified for CH1 to CH4.
Logic Edge Qualified: An edge qualified trigger based on the logic signal
The sources for edge detection and the qualifications can be selected from
PodA (0 to 7) to PodD (0 to 7)
3
State:: Triggers when the state condition changes from met to not met or from not met
to met
State conditions can be applied to all sources using AND or OR.
A clock channel can be specified that is used to determine the met or not met
state condition. No clock can also be selected.
The source and state clock can be set to a signal from CH1 to CH4.
Logic State:: A state trigger based on the logic signal
The source and state clock can be set to a signal from PodA(0 to 7) to PodD (0
to 7)
3
Pulse Width:: Triggers on the width of a single trigger source
The source can be set to a signal from CH1 to CH4, or EXT.
More than:: Triggers when the time length during which the condition is
met is longer than Time1, and the condition changes to not
met
Less than:: Triggers when the time length during which the condition is
met is shorter than Time1, and the condition changes to not
met
Between:: Triggers when the time length during which the condition
is met is longer than Time1 but shorter than Time2 and the
condition changes to not met
Out of Range:: Triggers when the time length during which the condition
is met is shorter than Time1 or longer than Time2 and the
condition changes to not met
Time Out:: Triggers when the time length during which the condition is
met exceeds Time1
Time:: Time1 and Time2: 1.5 ns to 10 s in 0.5 ns steps.
Minimum spacing between Time1 and Time2: 2ns
Time accuracy
2
±(0.2% of setting + 1 ns)
Minimum time
detection width:
2ns(Typical value
5
)
Logic Pulse Width:: A pulse width trigger based on the logic signal
The source and state clock can be selected from PodA (0 to 7) to PodD (0 to 7)
3
Pulse Qualified:: Triggers on the pulse width of a single trigger source while qualifications are
met
The source can be set to EXT or a signal from CH1 to CH4. Qualifications can
be specified for CH1 to CH4.
For details on the time settings, see “Pulse Width.”
Pulse State:: Triggers on the time-duration for which the state condition is met or not met
For a description of the state conditions, see “State Pattern.”
The sources and state clock can be selected from CH1 to CH4.
For details on the time settings, see “Pulse Width.”
Logic Pulse State:: A pulse state trigger based on the logic signal
The sources and state clock can be selected from PodA (0 to 7) to PodD (0 to 7).
3
18.2 Triggering Section

YOKOGAWA DL6000 Series Specifications

General

Brand	YOKOGAWA
Model	DL6000 Series
Category	Test Equipment
Language	English