2-20
IM DLM6054-01EN
History Search
When waveform acquisition is stopped, you can search for history waveforms that meet the specified
conditions.
section 11.2 for the procedure
You can search for history waveforms that did or did not pass through a specified search zone. The
three types of search zones are listed below.
•
Waveform Zone
You can create a zone on the screen using a waveform.
• Rectangular Zone
You can create a rectangular zone on the screen.
• Polygonal Zone
You can load a polygonal zone that you have created on a PC.
section 11.3 for the procedure
You can search for history waveforms that do or do not meet specified search parameter conditions.
The three types of search parameters are listed below.
•
Waveform Parameter
You can search for automated measurements of waveform parameters.
• FFT Parameter
You can search for FFT peak cursor measurements.
• XY Waveform Measurement Value
You can search for XY waveform areas or values that have been computed using XY waveform
areas.
2.5 Acquisition Conditions
To Next Page
Loading...
Need help?
General
