6-16 IM 701450-01E
Setting the Level, Hysteresis, Trigger Coupling, and HF Rejection
9. Press the Level/Coupling soft key. The Level/Coupling dialog box opens.
Setting the Level
10. Use jog shuttle & SELECT to set the level of each channel.
Setting the Hysteresis
11. Use jog shuttle & SELECT to set the hysteresis of each channel to
or .
Setting the Trigger Coupling
12. Use jog shuttle & SELECT to set the trigger coupling of each channel to DC or
AC.
Setting the HF Rejection
13. Use jog shuttle & SELECT to set the HF rejection of each channel to OFF,
20MHz, or 15kHz.
14. Press ESC. The Level/Coupling dialog box closes.
Setting the Number of Times Condition B Is to Be Met
15. Press the Count soft key.
16. Turn the jog shuttle to set the count.
Pressing RESET resets the value to 1.
Setting the Hold Off
17. Set the hold off time according to the procedures given in section 6.4.
6.8 Setting the A->B(N) Trigger (ENHANCED)
To Next Page
Loading...
