9-19
IM 701450-01E
9
Waveform Computation
9.9 Performing User-Defined Computation
(Optional)
<For a description of this function, refer to page 2-23.>
Procedure
X-Y
PHASE
MENU MENU
SETUP FILE
MISC
RESET
SELECT
MATH
SHIFT
GO/NOGO
CURSOR
MEASURE
HISTORY
PRINT
ACQ
START/STOP
IMAGE SAVE
DISPLAY
• To exit the menu during operation, press ESC located
above the soft keys.
• In the procedural explanation below, the term
jog shuttle & SELECT refers to the operation of
selecting/setting items and entering values using the
jog shuttle and SELECT and RESET keys. For details
on this operation, see sections 4.1 or 4.2.
• For a description of the operation using a USB keyboard
or a USB mouse, see section 4.3.
Note
Steps 3 to 7 describe the setup procedures for computed waveform Math1. Perform similar
steps for Math2.
Entering User-Defined Computation Mode
1. Press MATH. The MATH menu appears.
2. Press the Math Mode soft key to select User. The user-defined computation
menu appears.
If you select Normal, normal computation mode is enabled. For a description of the
procedure, see sections 9.1 to 9.8.
Turning ON/OFF the Computed Waveforms
3. Press the Math1 Display soft key to select ON or OFF.
• If ON is selected, the Math1 waveform is displayed.
• If OFF is selected, the Math1 waveform is not displayed.
Setting the Equation, Scaling, Unit, and Label
4. Press the Math1 User Define Setup soft key. The Math1 User Define Setup
dialog box opens.
To Next Page
Loading...
