10-54 IM 701450-01E
10.7 Performing Statistical Processing of the
Measured Values of Waveform Parameters
<For a description of this function, refer to page 2-30.>
Procedure
X-Y
PHASE
MENU MENU
SETUP FILE
MISC
RESET
SELECT
MATH
SHIFT
GO/NOGO
CURSOR
MEASURE
HISTORY
PRINT
ACQ
START/STOP
IMAGE SAVE
DISPLAY
• To exit the menu during operation, press ESC located
above the soft keys.
• For a description of the operation using a USB keyboard or
a USB mouse, see section 4.3.
1. Press MEASURE. The MEASURE menu appears.
2. Press the Mode soft key. The Mode menu appears.
Measuring Waveform Parameters and Performing Statistical Processing (Normal
Statistical Processing)
3. Press the Statistics soft key. The waveforms are measured and statistical
processing is performed. Then, statistics are displayed.
Display example of statistics
4. Perform the following setup procedures as necessary. For the operating
procedure, see section 10.6.
• Selecting the measurement parameters (steps 4 to 8 on page 10-46).
• Setting the delay measurement between waveforms (steps 9 to 18 on page
10-47).
• Turning ON/OFF 1 cycle mode (step 19 on page 10-48).
• Setting the measurement range (steps 20 and 21 on page 10-48).
• Setting distal, mesial, and proximal values (steps 22 to 31 on page 10-48).
• Setting high and low values (step 32 on page 10-49).
To Next Page
Loading...
Need help?
General
