10-1
IM 701450-01E
10
Analyzing and Searching Waveforms
Chapter 10 Analyzing and Searching Waveforms
10.1 Displaying History Waveforms
<For a description of this function, refer to page 2-17.>
Procedure
X-Y
PHASE
MENU MENU
SETUP FILE
MISC
RESET
SELECT
MATH
SHIFT
GO/NOGO
CURSOR
MEASURE
HISTORY
PRINT
ACQ
START/STOP
IMAGE SAVE
DISPLAY
• To exit the menu during operation, press ESC located
above the soft keys.
• In the procedural explanation below, the term
jog shuttle & SELECT refers to the operation of
selecting/setting items and entering values using the
jog shuttle and SELECT and RESET keys. For details
on this operation, see sections 4.1 or 4.2.
• For a description of the operation using a USB keyboard
or a USB mouse, see section 4.3.
1. Press HISTORY. The HISTORY menu appears.
Displaying History Waveforms One by One
2. Press the Select Record soft key.
3. Turn the jog shuttle to select the number of the record to be displayed.
You can select the record number in the range of Start Record to End Record shown
on the menu.
4. Press the Display Mode soft key to select One. Only the waveform of the
record number indicated in Select Record on the menu is displayed.
Accumulating (Collectively Displaying) the History Waveforms
Setting the Range to be Accumulated
2. Press the Start Record/End Record soft key to set the jog shuttle control to
Start Record or End Record.
• If you select Start Record, you can select the record number for starting the
accumulation.
• If you select End Record, you can select the record number for ending the
accumulation.
3. Turn the jog shuttle to set the record number at which accumulation is to be
started or ended.
4. Press the Display Mode soft key to select All. The waveforms in the range
between Start Record and End Record shown on the menu are accumulated on
the screen.
The waveform of the record number indicated in Select Record on the menu is
highlighted.
To Next Page
Loading...
