EasyManua.ls Logo

YOKOGAWA DL7440

YOKOGAWA DL7440
501 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16-2 IM 701450-01E
16.2 Messages and Corrective Actions
Messages
A message (or an error message) may appear during operation. This section describes
the meanings of the messages and their corrective actions. The messages can be
displayed either in English or Japanese (see section 15.1). If the corrective action
requires servicing, contact your nearest YOKOGAWA dealer.
In addition to the messages listed below, there are communication error messages.
These messages are described in the
Communication Interface User’s Manual
(IM
701450-17E, CD-ROM).
Status Messages
Code Message Corrective Action Sections
0 Aborted hard copy. 11.2
1 Aborted file operation. Chapter 12
2 Completed data store. 12.1
3 Completed data recall. 12.1
4 Completed GO/NO-GO. 10.9, 10.10
10 Set to remote mode by communication Press SHIFT + CLEAR TRACE to enable local
commands. mode.
11 Local lockout by communication commands. To operate the keys, release lockout using
communication commands.
13 All settings will be initialized. Power up with 4.4
the RESET key depressed.
21 Completed action-on-trigger. 6.16
22 Executed unload. 12.8, 12.9
23 Released the Preview mode. 11.2
24 Some of the channels are set to 50 ohm DC input. 5.4
To keep the settings, press the SELECT key.
Pressing any other key will change the settings
to 1 Mohm DC input.
25 Aborted the search. 10.2 to 10.4
26 Executed the search, but no record was found 10.2 to 10.4
that matched the conditions.
27 Executed the search, but no pattern was found 10.2 to 10.4
that matched the conditions.
28 Pattern contains points that are between Thr 10.4
Lower and Thr Upper.
29 MATH will be performed on all records.
Abort the operation by setting the history
Display Mode to One.
30 Aborted the recalculation of the MATH.
31 The logic option is not installed on this model. Page ii
32 Aborted statistical measurement processing. 10.7
36 Key invalid for this model.
37 Aborted the analysis.
38 Data not detected. Execute again after changing 10.11
the settings or reacquiring the waveform.

Table of Contents

Other manuals for YOKOGAWA DL7440

Related product manuals