YOKOGAWA DL7440 User Manual

9-2 IM 701450-01E
Assigning Labels to Computed Waveforms
4. Press Math1 Label. A keyboard used to enter values and strings appears.
5. Use jog shuttle & SELECT to set the label.
When the user-defined
computation option is installed
Explanation
This section describes the setup procedures that are common to the computations
described in section 9.2 to 9.8.
Switching the Computation Mode
If the user-defined computation option is installed, the computation mode can be
switched.
Normal
Switches to normal computation mode, and a menu for normal computation appears. For a
description of the setup procedure of the normal computation equation and the procedure for
displaying the waveform, see sections 9.2 to 9.8.
User
Switches to user-defined computation mode, and a menu for user-defined computation
appears. For a description of the setup procedure of user-defined computation, see section
9.9.
Turning ON/OFF the Computed Waveform Display
The display of the computed waveforms Math1 and Math2 can be turned ON/OFF
separately.
ON
Computed waveforms are displayed.
OFF
Computed waveforms are not displayed.
Computed Waveform Labels
Labels can be assigned to computed waveforms Math1 and Math2 using up to 8
characters.
• The type of characters that can be used are those displayed on the keyboard.
• For the procedure of turning ON/OFF the display of the assigned labels, see section
8.9.
9.1 Entering Normal Computation Mode, Displaying Computed Waveforms, and Assigning Labels to
Computed Waveforms

YOKOGAWA DL7440 Specifications

General

Brand	YOKOGAWA
Model	DL7440
Category	Test Equipment
Language	English