11-2 IM 701450-01E
Printer cover
Handle
Lock release lever
To open the printer cover, lift the handle on the
left side of the printer cover while pressing the
lock release lever to the OPEN direction.
Release arm
Movable holder
Move the release arm located on the right near
the front to the MAN FEED position. Hold the roll
paper so that the inner side of the roll paper (the
side that is not glossy) is facing up. Pull the
movable holder to the left, then insert the roll
paper ride-side first into the tray. Release the
movable holder to secure.
MAN FEED
Turn the paper
feed knob
Roll paper
Release arm
Guide
Roller
Insert the edge of the roll paper evenly in the
space between the roller and the black guide,
then rotate the paper feed knob towards you until
about 10 cm of the paper extends beyond the top
of the roller.
FREE
HOLD
Move the release arm to the FREE position and
straighten out the paper. Then, move the release
arm to the HOLD position. The printing will fail
with an error message if the release arm is in the
FREE or MAN FEED position during operation.
Pull the printer cover back to its original position
and close the cover. Make sure that the edge of
the roll paper feeds through the opening of the
printer cover. Push the printer cover down firmly
until it clicks into place.
Note
The paper feeding may not be stable immediately after the roll paper is installed. Print 2 or 3
pages of test images in advance.
11.1 Installing the Roll Paper into the Built-in Printer (Optional)
To Next Page
Loading...
Need help?
General
