13-42 IM 701450-01E
Explanation
Set the time difference from GMT (Greenwich Mean Time). Make sure to set this value if
you are using the Web server function.
Setting the Time Difference from GMT (Greenwich Mean Time)
Set the time difference in the range of –12 hours 00 minutes to 13 hours 00 minutes.
For example, Japan standard time is ahead of GMT by 9 hours. In this case, set Hour to
9 and Minute to 00.
Checking the Standard Time
Check the standard time for the region where the DL7400 is to be used using one of the
following methods.
• Check the date and time settings on your PC.
• Check the site at the following URL:http://www.worldtimeserver.com/
Note
The DL7400 does not support daylight savings time. To set the daylight savings time, adjust the
time difference from GMT.
Setting SNTP
If Exec at power On is ON, the DL7400 retrieves date/time information from an NTP
server or SNTP server connected to the network when the power to the DL7400 is
turned ON.
Note
• If the time difference from GMT (Greenwich Mean Time) is specified, the time is set to a value
derived by calculating the difference between the time retrieved from the SNTP server and
the time difference.
• The date/time information can also be retrieved from an NTP server or SNTP server when
you are setting the date/time on the DL7400. For details, see section 3.7, “Setting the Date
and Time.”
• If you do not wish to retrieve date/time information from the NTP server or SNTP server,
leave the IP address blank.
13.8 Setting the Time Difference from GMT (Greenwich Mean Time)
To Next Page
Loading...
