4-2 IM 701450-01E
Operations on the Setup Dialog Box
In the explanations in this manual, “jog shuttle & SELECT” refers to the following
operation.
1. Open the setup dialog box using basic key operations or other means.
2. Turn the jog shuttle to move the cursor to the desired item.
3. Press SELECT. The behavior that results when you press SELECT varies
depending on the item as described below.
* When selecting a medium, directory, or file name on the File List window, you operate
the jog shuttle to move the cursor and select using the SELECT key. This operation is
also referred to as “jog shuttle & SELECT.”
I
J
Setup dialog box
Turn the jog shuttle to move the
cursor to the item you wish to set.
When Mode is selected (H) When Edge Count is selected (J)
H
Value entry box
Selection menu
H: Press SELECT to display the selection menu.
Turn the jog shuttle to move the cursor to the item you wish to set.
Press SELECT to confirm the selection.
I: Press SELECT to switch the selected item.
J: Press SELECT to display the value entry box.
Turn the jog shuttle to set the value.
Press the arrow keys to change the selected digit.
You can directly enter the value from a USB keyboard.
Press RESET to set the item back to the initial setting.
Clearing the Setup Menu and Setup Dialog Box Displays
Press ESC. The setup menu or the dialog box shown on top is cleared from the
screen.
Note
• In the procedural explanations in this manual, the operation of clearing the setup menu or
setup dialog box may not be given.
• If the setup menu is cleared when the automated measurement values of waveform
parameters or cursor measurement values are displayed in the waveform display area, these
measured values are displayed at the display position of the setup menu.
4.1 Operations and Functions of Keys and the Jog Shuttle
To Next Page
Loading...
