4-18 IM 701450-01E
Setup Data after Executing Auto Setup
Waveform acquisition/display conditions
Acquisition mode Normal
Acquisition Count Infinite
Record length 10 k
Interleave mode OFF
Time base Int
Accumulate mode OFF
Zoom target Channels that are turned ON
Waveforms whose Allocation on the ZOOM menu is OFF are not
displayed.
Vertical-axis settings
V/div Value that causes the absolute value of the input waveform to be 1.6 to 4
divisions
Offset voltage 0 V
Coupling DC1MΩ for inputs other than DC50Ω and DC50Ω for DC50Ω
Bandwidth limit FULL
Display ON/OFF Turns ON channels whose absolute value of the input voltage is greater
than or equal to 20 mV (1:1)
Position 0 divisions
Horizontal-axis settings
T/div Value that the displays 1.6 to 4 periods of the waveform with the shortest
period of the auto setup target waveforms
Trigger settings
Trigger mode Auto
Trigger type Simple
Trigger source Channel whose waveform amplitude is greater than or equal to 1 division
with the longest period
Trigger level/slope Center level between the maximum and minimum values/rising
Trigger coupling DC
HF rejection OFF
Hysteresis
Hold off time 80 ns
Trigger position 50%
Trigger delay 0 s
Trigger gate OFF
Computation settings
Scaling Auto
Items other than those listed above are not applicable for auto setup.
4.5 Performing Auto Setup
To Next Page
Loading...
