YOKOGAWA DLM4000 Series User Manual

2-70
IM DLM4038-02EN
Waveform Zone (WaveZone)
Press the WaveZone soft key to display the following menu.
Reference standard. The waveform zone appears when this is set to IN or OUT.
Set the reference range type (WaveZone).
Set the GO/NO-GO determination source window (Main, Zoom1, or Zoom2).
Set the waveform zone to edit (1 to 4).
GO/NO-GO determination is performed using
the waveform zone that you specify here.
Edit the waveform zone.
Set the source waveform (CH1 to CH8, Math1 to Math4
*
).
* Math1 to Math4 can be specified when the reference condition is 1 or 3.
• Set the left side.
• Set the right side.
Set the GO/NO-GO determination area.
Editing a Waveform Zone (Edit1 to 4)
1.
Press the Zone No. soft key, and select the number, from 1 to 4, of the waveform zone that you
want to edit.
The soft key for editing the waveform zone will change (to Edit 1, 2, 3, or 4) according to the selected
number.
2.
Press the soft key for editing the waveform zone (Edit 1, 2, 3, or 4).
The waveform zone editing menu for the number that you selected will be displayed.
Editing the Whole Waveform
3.
Press the Edit soft key and select Whole to display the following menu.
Set the editing range (Whole).
Set the horizontal range.
Set the vertical range.
Restart editing.
Confirm the changes to the waveform zone.
• Set the top side.
• Set the bottom side.
• Set the left side.
Configure the range of the
waveform zone.
Configure the range of the
waveform zone.
• Set the right side.
Change the base waveform (CH1 to CH8,
Math1 to Math4).
Stop editing.
2.23 Performing GO/NO-GO Determination

YOKOGAWA DLM4000 Series Specifications

General

Brand	YOKOGAWA
Model	DLM4000 Series
Category	Test Equipment
Language	English