2-28
IM DLM4038-02EN
• When ID Input Format Is Message
Set data reference values a and b.
SOF (always selected)
Set the ID input format (Message).
Set the comparison condition.
Select an ID from the message list in
the loaded physical value/symbol
definition file (.sbl).
Select a data item from the signal list in
the loaded physical value/symbol
definition file (.sbl).
ID OR Mode (ID OR)
Press the Mode soft key and then the ID OR soft key to display the following menu.
Set the trigger conditions. ► “ID OR Mode” in
section 2.10
Set the trigger type to ID OR.
2.11 Triggering on CAN FD Bus Signals (Option)
To Next Page
Loading...
