2-41
IM DLM4038-02EN
Error Mode
Press the Mode soft key and then the Error soft key to display the following menu.
Set the slow channel message
type (Short, Enhanced).
This is selectable when the format
version is JAN2010.
Set error detection on or off.
Slow CH CRC
Nibble Number
Nibble Data Value
Fast CH CRC
Status and Communication
2
Successive CAL Pulses
1
1 Not selectable when Successive Calibration Pulses is set to OFF for Customize Error Factor in
“Setting the Format (Format)” (page 2-36).
2 Selectable when the Bit 0 or Bit 1 check box is selected under Status and Communication for
Customize Error Factor in “Setting the Format (Format)” (page 2-36).
The DLM4000 triggers when it detects various types of errors.
2.13 Triggering on SENT Signals (Option)
To Next Page
Loading...
