28 Oct
1997 21:57
CELL-DYN
®
3/35 Sample Loader TS Guide 9140234B-June 1997
VERIFICATION PROCEDURES
VP - 6.5 Mixing Limit Sensor Check/Adjustment
3 - 107
3
Search
Book TOC
Go Back
6. Ensure REPEAT LED is flashin
.
7. Loosen limit sensor mountin
screws.
8. Put volt meter
+
lead on TP Pin 4 (Fi
ure 3-56).
9. Put volt meter
-
lead on GND.
Figure 3-56 Mixing Home and Limit Pin Locations
10.Adjust limit sensor position until TP Pin 4 just to
les from +5.0V (blocked) to
≈
0.0V (unblocked).
SL-131B
TP
[NON- CE MARK]
Pin 4 Mixin
Limit
Pin 2 Mixin
Home
Pin 10
Mixin
Limit
Pin 4
Mixin
Home
CN5
[CE MARK]
To Next Page
