Agilent Technologies 35670A - Page 318

scaling (continued)
manual Y-axis 10-3 - 10-4
matching scale of two traces 10-6, 10-8
resetting X-axis scale 10-7
resetting Y-axis scale 10-5
with axes scale markers 10-5, 10-7
screen
adjusting brightness 9-6
enabling external 9-6
turning on and off 9-6
screen saver 9-6
serial port 14-3
setting up a curve fit 16-30, 16-34
settling time 5-11
sideband power 4-8
signal-to-noise ratio
computing 18-12
skewing a waterfall 9-8
slice through a waterfall 9-11
sound pressure level
See SPL
source
See also arbitrary source
creating profiled chirp signal 6-8
creating ramp signal 6-6
creating step signal 6-4
impedance Part I-11
periodic chirp 4-11
span
maximum in FFT mode 4-2
time capture restrictions 7-11
SPL
displaying overall bands 9-4
general 3-6
overall 3-8
state, saving 13-9
step response 5-8 - 5-9
step signal, creating 6-4
stop bits 14-3
structures, driving point
measurement 2-10
sweep, linear vs log 4-13
swept sine analysis 4-12
synthesis
analyzer configuration 15-25
building pole-residue equations 15-10
calculation of 15-3
changing data register 15-35
changing table format 15-16 - 15-17
clearing a table 15-24
converting tables 15-13
synthesis (continued)
copying from a
curve fit table 15-34, 16-38
creating a table 15-18, 15-22
data formats 15-4
delay 15-20
displaying a table 15-15
frequency response 15-26
frequency scale 15-21
frequency scaling 15-23
frequency span 15-25
gain factor 15-19, 15-23
Laurent terms 15-13
NaN marker value 15-13
non-Hermitian entries 15-7, 15-13
numeric range 15-29
optional parameters 15-23
partial fraction format 15-16
pole-residue data 15-6
pole-residue example 15-10
pole-residue format 15-16
pole-zero data 15-4
pole-zero example 15-5
pole-zero format 15-15
polynomial data 15-11
polynomial format 15-17
recalling a table 15-33
reconstructing complex
conjugate pole-pairs 15-8
reconstructing simple poles 15-7
saving a table 15-31
start frequency 15-25
stop frequency 15-25
storing a trace 15-32
time delay 15-20, 15-23
X-axis spacing 15-25, 15-28
synthesis table
changing format 15-16
clearing 15-24
creating 15-18, 15-22
displaying 15-15
editing 15-30
recalling 15-33
saving 15-31
T
tachometer
characterizing signal 1-8 - 1-9
readout 9-3
using as phase reference 1-18
vi