To save a synthesis table
1 Specify the default disk. (See “To select the default disk” in chapter 13, “Saving Your
Work.”)
2 Press [
Save Recall
][
SAVE MORE
][
SAVE SNTH TABLE
].
3 Using an external keyboard (or the front-panel alpha keys), type an appropriate
filename. The default is SYNT1.SYN.
4 Press [
ENTER
].
You should use the .SYN suffix to delineate synthesis files from other types of files.
You can store a synthesis table into the analyzer’s non-volatile RAM (NVRAM),
RAM or internal disk. Step 1 specifies where you store the synthesis table. You can
also store a table to an external disk via the GPIB. For more information, see
GPIB Programming with the Agilent 35670A.
Agilent 35670A
Operator's Guide Synthesis Option 1D3
15-31
To Next Page
Loading...
Need help?
General
