Agilent Technologies 35670A User Manual

To format a flexible disk
1 Select the analyzer’s internal disk drive as the default disk (as described in the
previous task).
2 Insert a double-sided, 3.5-inch flexible disk into the internal disk drive.
3 Press [
Disk Utility
][
FORMAT DISK
][
INTRLEAVE FACTOR
]0[
ENTER
].
4 If you want the disk formatted for MS-DOS®
*
,press[
DISK TYPE LIF DOS
] to highlight
DOS.
or
If you want the disk formatted for LIF, press [
DISK TYPE LIF DOS
] to highlight LIF.
5 Press [
PERFORM FORMAT
][
ENTER
].
CAUTION You can damage both the disk and the drive if you attempt to eject a disk when
the “FORMAT DISK In Progress” message is displayed or when the disk’s “busy”
light is on.
You must format a 3.5-inch flexible disk before you can use it to store Agilent 35670A
data. Use a double-sided disk—either double-density or high-density—that is not
write-protected. The analyzer takes about two and a half minutes to format a disk and
is unavailable for other tasks during that time. For information on the formatting
parameters, use online help.
*
MS-DOS is a U.S. registered trademark of Microsoft Corporation.
Do not eject the disk when
the “busy” light is on.
Use a 3.5-inch flexible disk (DS
DD or DS HD).
The disk-eject button.
Agilent 35670A
Managing Files and Disks Operator's Guide
13-4

Agilent Technologies 35670A Specifications

General

Brand	Agilent Technologies
Model	35670A
Category	Measuring Instruments
Language	English