Agilent Technologies 35670A

To edit an existing synthesis table
1 Press [Analysis][
SYNTHESIS
].
2 Display the current synthesis table.
Press [
TABLE ON OFF
] to highlight ON.
3 Press [
EDIT TABLE
].
4 To add a value to the synthesis table,
press [
ADD VALUE
] <number><unit>.
5 To delete a value, use the knob to move the highlighted bar over the entry you want to
delete,
press [
DELETE VALUE
].
If you make a mistake, press [
UNDELETE VALUE
].
6 If you want to change or correct a value, move the highlighted bar over the entry you
want to modify.
Press [
CHANGE VALUE
] <number><unit>.
In step 1, you can recall the synthesis table or transfer a curve fit table.
Agilent 35670A
Synthesis Option 1D3 Operator's Guide
15-30