Agilent Technologies 35670A

To enable trace-specific screen elements
1 Activate the trace you want to modify.
2 If you want to display the trace grid, press [
Disp Format
][
MORE
], then press
[
GRID ON OFF
] to highlight ON.
3 If you want to display the overall SPL band for octave-mode measurements, press
[
Disp Format
][
MORE
][
OCTAVE BND SETUP
], then press [
OVERALL ON OFF
]to
highlight ON.
4 If you want to display the A-weighted overall SPL band for octave-mode
measurements, press [
Disp Format
][
MORE
][
OCTAVE BND SETUP
], then press
[
WEIGHTED ON OFF
] to highlight ON.
5 If you want to display the marker readout, press [
Marker
], then press
[
MARKER ON OFF
] to highlight ON.
If the trace grid is turned off, it will not be displayed on the screen and it will not be
plotted or printed. If the marker readout is not displayed when you set
[
MARKER ON OFF
] to ON, check to be sure that X-and Y-axis annotation is enabled for
the entire screen: the previous task shows you how.
Marker readout ON
Overall bands ON
Trace grid ON
Agilent 35670A
Formatting the Display Operator's Guide
9-4