To recall a synthesis table
1 Specify the default disk. (See “To select the default disk” in chapter 13, “Managing
Files and Disks.”)
2 Press [
Save Recall
], then press [
CATALOG ON OFF
] to highlight ON.
3 Press [
RECALL MORE
][
RCL SYNTH TABLE
].
4 Using the knob, highlight the filename you want to recall.
5 Press [
ENTER
].
You can recall a synthesis table from the analyzer’s non-volatile RAM (NVRAM),
RAM or internal disk. Step 1 specifies where the synthesis table is stored. You can
also recall a table from an external disk via the GPIB. For more information, see
GPIB Programming with the Agilent 35670A.
Agilent 35670A
Operator's Guide Synthesis Option 1D3
15-33
To Next Page
Loading...
