Agilent Technologies 5DX Service Guide

Index-2
5DX Series 3
Image Generation Components 8-9
System Controller 8-9
Overview 8-2
Inner Barrier 5-2, 5-3, 5-15, 6-6, 6-12, 6-13,
6-15, 6-22, 10-42
Inner Barrier Control 5-42
L
Labels Used on Equipment 2-2
Laser
Displacement Sensor 7-9
Safety 2-14, 7-6
Signal Flow Diagram 7-7
View Camera and Halogen Lamp 7-9
Low Voltage Assembly 4-15
M
Maintenance 10-1
Electronics Bay
Check the Focus Coil Power Supply
Setting 10-15
Clean all Filters and Fans 10-18
General
Check Operation of the System Status
Beacon. 10-7
Check the Panel View Camera Light
10-13
Check X-ray Hight Voltage Power
Supply Status 10-9
Check X-ray Tube Dielectric Pressure
10-11
Introduction 10-2
Main Cabinet
Check the Auto Width Adjust 10-37
Check the System Air Pressure/Low
Pressure Regulator 10-26
Check the Vac-Ion Power Supply 10-22
Clean and Inspect the Main Cabinet
10-39
Clean and Inspect the Rotary
Scintillator Shield 10-36
Inspect Left and Right PIP Sensor Flags
10-31
Inspect Main Cabinet Cables 10-29
Inspect the Laser Camera Lights 10-27
Inspect the XYZ Stage Conveyor Belts
10-30
Lubricate the XYZ and Auto width
Lead Screws. Inspect and Lubricate
the Z axis 10-33
Lubricate XYZ Stage Rail Cars 10-40
Replace the Conveyor Belt Motor
Control Relays 10-41
Replace the XYZ Stage Conveyor Belts
10-41
PM checklist 10-4
Preventative 10-2, 10-4
Software Diagnostics
Backup the Hard Drive 10-45
Check the Inner Barrier Encoders 10-42
Run Position Repeatability Test 10-43
Run Resolution Test 10-44
Run the Confirmation and Adjustment
Procedures 10-45
X-ray Safety Test 10-45
Motion and Digital I/O Controller 2 5-41
Automatic Width Adjust Control 5-42
Inner Barrier Control 5-42
Rotary Axis Control 5-41
Motion Control Assembly 4-15, 5-18, 5-28
Automatic Width Adjust Stepper Driver
and Z-Axis Stepper Driver 5-33
Backplane 5-33
Diagnostic Access Module 5-29
Diagnostic LEDs 5-30
Diagnostic Test Points 5-30
Motion Enable Control 5-34
Motor Relay Control 5-35
Motion Controller
PCI 1 5-38
X-Axis Control 5-38
Y-Axis Control 5-39
Z-Axis Control 5-40
Software 5-51
Motor Relay Control

Agilent Technologies 5DX Specifications

General

Brand	Agilent Technologies
Model	5DX
Category	Medical Equipment
Language	English