Agilent 5DX Service Guide Index-3
5DX Series 3
Diagnostic LEDs 5-36
Diagnostic Test Points 5-37
O
Operator Control Console 3-14, 4-27
Outer Barrier 2-4, 4-20, 5-14, 6-2, 6-11, 6-12
P
Panel Handling
Automatic Flow Through Mode 5-5
Automatic Pass Back Mode 5-4
Configurations 5-4
Configuring a System 5-6
Modes 5-4
Dual Panel Test Mode 5-6
Hardware Status and Control 5-51
Manual Flow Through Mode 5-6
Manual Pass Back Mode 5-5
Software 5-51
Subsystem 5-1
Components 5-13
Digital I/O Assembly 5-42
Introduction 5-2
Motion Controller PCI Cards 5-38
Panel Movement 5-2
Positioning of Movable Barriers 5-3
X-ray Cabinet and Barriers 5-14
XYZ Stage Assembly 5-16
XYZ Stage Conveyor Belts 5-22
Panel View
Camera 10-13
Camera Assembly Components 7-10
CCD Camera and Halogen Lamp 7-10
Part Numbers
Inner Barrier Safety Interlocks 3-11
Outer Barrier Safety Interlocks 3-12
Pneumatic Subsystem 6-1
Components 6-3
Adjusting the Air Cylinder 6-14
Adjustment/Replacement Inner Barrier
Encoder 6-16
Barrier Operation 6-11
Inner Barrier 6-8
Internal Manifold 6-7
Main Safety Valve 6-6
Other Inner Barrier Components 6-15
Pneumatics Regulator and Filter
Assembly 6-4
Setting the Positions for the Encoder
6-20
Power Distribution Unit 2-4, 2-12, 4-4, 4-5,
4-25, 4-28
Controls and Indicators 4-6
Emergency Shutdown 4-7
High/Low Line Monitoring/Protection
4-7
Input Specifications 4-5
On Switch Location 4-25
PDU Circuit Breakers and Fuses 4-8
Power Switch Location 4-4
Switch and LED location 4-28
Switched Output Terminals 4-5
Unswitched Output Terminals 4-6
Power Subsystem 4-1
Overview 4-2
Power Supply
Camera Power Supply 4-17
Focus Coil 4-15
VacIon Pump 4-17
X-ray High Voltage Power Supply 4-18
R
Rotary Scintillator 1-4, 2-12, 4-17, 8-4, 8-9,
8-10, 8-11, 8-20, 8-22, 8-23, 10-36
Run Position Repeatability Test 10-43
S
Safety Interlock 1-2, 1-11, 1-13, 2-3, 2-8,
2-9, 2-10, 2-12, 2-14, 3-6, 4-15, 4-23,
4-26, 4-29, 6-10, 6-15, 7-6
Chains 3-10
Adjusting the Outer Barrier’s Primary
Safety Interlock 3-18
To Next Page
Loading...
Need help?
General
