249
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_syntax_book_diagr_convent.fm
Diagram Conventions
Complex Command Description
A complex command sets the state of the parameter to ON, and is used to set a value for that parameter. These
parameters; amplitude, frequency, gain, number, time, and value can be used as a complex command. Refer to
the specific command for the parameter that applies.
Identifier Description
Some test applications are able to test more than one radio format. There may be commands/queries that are
shared by more than one radio format in the some of these test applications. Identifiers are used to specify the
radio format for the command/query. The command/query is sent to the active radio format if you don’t use an
identifier. An identifier must be used when sending commands to the inactive radio format.
Developing Code
It is recommended that you set the Test Set’s operating environment to debug. To set the Test Set debug mode
to "ON" use the following syntax:
SYSTem:COMMunicate:GPIB:DEBug ON
Units-of-Measure
Amplitude (linear) V
Frequency Hz
Power (logarithmic) dBm
Time s
To Next Page
Loading...
Need help?
General
