397
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_call_status.fm
CAL L: S TATus
CALL:STATus:SCHannel:STATe[:SELected]?
CALL:STATus:SCHannel:SYNChronized?
CALL:STATus:SYNC:LEVel[:SELected]?
CALL:STATus:SYNC:STATe[:SELected]?
Function Queries the current on/off state of the forward supplemental channel (SCH).
The forward supplemental channel on/off state is set using the “CALL:SCHannel” commands.
The optional [:SELected] keyword in this command specifies that the supplemental channel state
being queried applies to the current system type.
Query Range: 1|0
*RST Setting 0 (Off)
Programming Example
OUTPUT 714;"CALL:STATUS:SCHANNEL:STATE?"
Function Queries the if the data on the F-SCH is synchronized when in SO32 (TDSO). This is primarily
used by the TDSO FER measurement. The returned setting is NSCH (no F-SCH assignedl),
NSYN (not synchronized), or SYNC (synchronized.
The forward supplemental channel on/off state is set using the “CALL:SCHannel” commands.
Query Range: NSCH|NSYN|SYNC
*RST Setting NSCH
Programming Example
OUTPUT 714;"CALL:STATUS:SCHANNEL:SYNCHRONIZED"
Function Queries the current forward sync channel level for the currently selected system type.
The forward sync channel level is set using the “CALL:SYNC” commands.
The optional [:SELected] keyword in this command specifies that the sync level being queried
applies to the current system type.
Query Range: 0 to -20 dB, 9.91 E+37
Resolution: 0.01 dB
*RST Setting 9.91 E+37
Programming Example
OUTPUT 714;"CALL:STATUS:SYNC:LEVEL:SELECTED?"
Function Queries the current sync channel level state for the currently selected system type.
The forward sync channel level on/off state is set using the “CALL:SYNC” commands.
The optional [:SELected] keyword in this command specifies that the sync state being queried
applies to the current system type.
To Next Page
Loading...
