558
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_setup_saudio.fm
SETup:SAUDio
SETup:SAUDio:CONTinuous
SETup:SAUDio:COUNt[:SNUMber]
SETup:SAUDio:COUNt:NUMBer
Function Sets/queries the trigger arm state for the swept audio measurement. Determines whether
measurement will make one measurement then stop (0|OFF (single)), or automatically rearm
upon completion of one measurement and repeat the process (1|ON (continuous)).
Setting Range: 1|ON|0|OFF
Query Range: 1|0
*RST Setting 0 (off)
Programming Example
OUTPUT 714;"SETUP:SAUDIO:CONTINUOUS ON” !Turns on continuous triggering.
Function Sets/queries the number of audio measurements to perform at each measurement point in a
single multi-measurement sweep. This command sets the count, and automatically sets the
multi-measurement STATe command to 1 (on).
Setting Range: 1 to 999
Query Range: 1 to 999
*RST Setting 10
Programming Example
OUTPUT 714;"SETUP:SAUDIO:COUNT:SNUMBER 5” !Turns on multi-measurements and makes 5
measurements at each frequency point in the sweep.
Function Sets/queries the number of audio measurements to perform at each measurement point in a
single multi-measurement sweep when the “SETup:SAUDio:COUNt:STATe” is set to 1 (on).
Setting Range: 1 to 999
Query Range: 1 to 999
*RST Setting 10
Programming Example
OUTPUT 714;"SETUP:SAUDIO:COUNT:NUMBER 5” !Makes 5 measurements at each frequency point in
the sweep.
To Next Page
Loading...
