632
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_system_application.fm
SYSTem:APPLication
SYSTem:APPLication:SELect[:NAME] ‘<test application name>’
Function Selects a test application and reboots the test set. This will switch the test application to the
revision already selected. There is no need to re-select the revision before switching. The reboot
process takes about 1 minute.
Queries the test set for the test application that is selected and will run after the next reboot of
the test set. This string is not case sensitive.
The test application name must be entered as it appears in the test application Setup menu, with
the exception that the string is not case sensitive and can be entered in any combination of upper
and lower case letters.
NOTE Selecting the correct name and the desired revision of a test application is
important. This information should be reviewed before proceeding. The directions
for how to determine test application name and revision are found in this
document.
Setting Range:
AMPS/136 Mobile Test
CDMA 2000 Mobile Test
GSM Mobile Test
GPRS Mobile Test
Query Range:
AMPS/136 Mobile Test
CDMA 2000 Mobile Test
GSM Mobile Test
GPRS Mobile Test
null string
Programming Example
OUTPUT 714;"SYSTEM:APPLICATION:SELECT:NAME ‘AMPS/136 MOBILE TEST’"
OUTPUT 714;"SYSTEM:APPLICATION:SELECT:NAME?"
To Next Page
Loading...
Need help?
General
