644
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_system_correction.fm
SYSTem:CORRection
SYSTem:CORRection:STATe
Function Sets/queries the RF IN/OUT Amplitude Offset State. The state must be On before any of the
offsets are active regardless of the state for any of the frequencies or offsets.
When the RF IN/OUT Amplitude Offset State is On, the Instrument Status Area will indicate
“Offset" regardless of the state for any of the frequencies or offsets.
Setting any of the frequency or offset states to On will set the RF IN/OUT Amplitude Offset State
to On.
See “Measurement Related Configuration” on page 81.
Setting 0|OFF | 1|ON
Query 0|1
Factory
Setting
0 (off)
Programming Example
OUTPUT 714;"SYSTEM:CORRECTION:STATE ON" !Sets the RF IN/OUT
!Amplitude Offset State to On
To Next Page
Loading...
