689
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_gen_rearpanel_con.fm
Rear Panel Connectors
BASEBAND I/O
Not functional for this release.
CLK IN
Not functional for this release.
COUNTER IN
Not functional for this release.
DATA IN
Not functional for this release.
DATA VALID IN
Not functional for this release.
ETHERNET TO FRONT PANEL
This RJ-45 connector is used with a separate LAN jumper cable to connect the front panel DATA connector to
the rear panel LAN PORT.
The the DATA connector on the front panel is connected internally to the ETHERNET TO FRONT PANEL
connector on the rear panel. In order to use the front panel DATA connector the user must connect the rear
panel LAN PORT, to the rear panel ETHERNET TO FRONT PANEL connector with the LAN jumper cable.
The LAN jumper cable, part number E5515-61160, is supplied with the test set.
EXT INTERFACE CONTROL
Not functional for this release.
EXT SIG GEN/FRAME SYNCH
Not functional for this release.
FM MOD IN
This BNC connector let’s you use an external signal to frequency modulate the test set’s RF generator. It has a
fixed sensitivity of 20 KHz/volt, and a frequency range of 100Hz to 20 KHz.
GPIB
The GPIB connector allows test set control with compatible devices.
To Next Page
Loading...
Need help?
General
