Chapter 5 245
Making Measurements
Setting the Point Trigger
5. Making Measurement
Setting the Point Trigger
The point trigger provides a point measurement at every trigger, and it can be used to
change the trigger event to point trigger mode.
Table 5-4 Trigger mode
Trigger event name Function
On (On Point) Point measurement is performed when trigger is applied.
Off (On Sweep) Measurement is performed for all measurement points when
trigger is applied.
NOTE When the trigger source is selected as the internal trigger, the point trigger does not work.
Procedure to Set the Point Trigger
1. Selecting a Trigger Event
Follow the procedure below to select a trigger event.
Step 1. Press .
Step 2. Press Trigger Event.
Step 3. Press the softkey that corresponds to the desired trigger event.
Softkey Function
On Point Measures at each measurement point
On Sweep Measures all measurement points
To Next Page
Loading...
