Appendix A 599
Manual Changes
Manual Changes
A. Manual Changes
Figure A-14 Four-port Touchstone file
Change 10
The firmware revision A.05.00 or lower does not support the following functions. Please
delete the descriptions about these functions from this manual.
o User preset function
o Function to display the marker values for non-active traces.
o Function to change the display position where the marker values are displayed.
o Function to align the marker values.
o User recovery function
*1
o TRL calibration by softkeys
o Function to set the waveguide as the media type.
o Loss correction.
o Function to automaticall calculate the port extension and loss values.
o Function to turn off the auto-detect function of the Ecal module (Manual setting is
available).
o Conversion function for differential/common port reference impedance of the fixture
simulator in “Complex” format.
*1.This function is available when the volume label on the C-drive is CP600 or higher.
To Next Page
Loading...
