Agilent Technologies ENA Series

Chapter 13 437
Setting and Using the Control and Management Functions
Configuring the Network
13.Setting and Using the
Control and Management
Functions
Step 8. In the Internet Protocol (TCP/IP) Properties dialog box, click the OK button (6 in Figure
13-13).
Step 9. In the Local Area Connection Properties dialog box, click the OK button (3 in Figure
13-12).
Step 10. In the Local Area Connection Status dialog box, click the Close button (3 in Figure 13-11).
Step 11. Click the × button (2 in Figure 13-10) in the upper right of the Network and Dial-up
Connections window.
Specifying computer name
Follow these steps to specify the computer name:
Step 1. Press .
Step 2. Press Misc Setup.
Step 3. Press Network Setup.
Step 4. Press Network Identification.
Step 5. The System Properties dialog box (Figure 13-14) appears. Click the Properties button (1
in Figure 13-14).
Figure 13-14 System Properties dialog box