630 Appendix C
List of Default Values
List of Default Values, Save/Recall Settings, and Backup Settings
List of Default Values, Save/Recall Settings, and Backup
Settings
The table below shows the following settings for the Agilent E5070B/E5071B.
• Factory-shipped settings
• Settings valid when you press (Or when you execute the :SYST:PRES
command)
• Settings valid when you execute the *RST command
• Settings that permit Save/Recall of a setup state
In the table, states that can be saved/recalled are denoted in the following manner:
√: Save/Recall can be performed
Blank: Save/Recall cannot be performed
• Settings that are backed up (set state not affected by turning power ON/OFF)
In the table, a setting that is automatically backed up is denoted in the following
manner:
√: Backup operation performed
Blank: Backup operation not performed
• Available means of defining a setting
In the table, the following symbols are used to denote the method(s) that can be used to
define a setting.
K: Using the front panel key (including the mouse and keyboard)
C: Using the SCPI command or COM object
NOTE In the table, the ← symbol shows that the setup is the same as that in the box to the left.
To Next Page
Loading...
